devention Scout X4 Quick Start Manual And Systems Flowchart page 13

M1
0
Or. -II M2
-Al M3
-41 M4
M5
11.
ms
110-4
M7
pm' po.P4
esn 160dt1LVO ssvewoT
i r
Main controller
E
MADE IN CHINA
AUX 3 IP
AUX 21.
AUX 1 IP
GEAR IP
RUDD IP
THRO I1P
ELEV ►
RILE 11.
CHECK POWER IP
DATA SUS IP
JUMP PORT. IP
(JeUenton
FCS—X4
TT,
TELEMETRY CON
cleVention
RX
,VO V
CE
DATA BUS
AUX1
AUX2
AUX3
AUX4
AUX5
AUX6
MATE IN CHINA AUX]
13.0 FCS-X4 Main controller guideline
®
To roundly cruise flight mode ® To check voltage(connect with power board) (it Connect with fifth way brushless ESC
0 To hyper IOC
0
Used for data transmission-connect the PPM OUT
port of BT-2401A/2402A
0 Connect with forth way brushless ESC
® To one key to take off
® Jumper port, when regular receiver is
need, insert random equipped bind plug pls.
0 Connect with third way brushless ESC
® Control Mode Switch a To link LED
qo Connect with second way
brushless ESC
0 To control Rudder CD To link GPS module(red white blue black four color cable) 0 Connect with first way brushless ESC
0 To control Throttle (3 Connect with eighth way brushless ESC 0 Upgrade channel
® To control Elevator
(forward & backward)
@ Connect with seventh way brushless ESC @ Data communcation port
® To control Aileron
(leftward & rightward)
0 ,
Connect with sixth way brushless ESC
4
- 3 1 To link Compass
(red black double color cable)
14.0 DEVO RX707(CE)/RX709(FCC) Receiver guideling
AUX3: Roundly cruise flight mode(no need to connect)
AUX4: Connect the servo of landing skid-connect the PWM3 IN port of BT-2401A/2402A
AUX5: Connect gimbal Roll singal cable-connect the PWM 2 IN port of BT-2401A/2402A
UX6: Connect gimbal PIT singal cable-connect the PWM 1 IN port of BT-2401A/2402A
AUX7: Connect camera controller/Clear fix ID code(When clear fix ID code is need, insert random equipped bind plug pls).
Attention: DEVO RX707(CE) and DEVO RX709(FCC)have the same port
• 12 •
Telemetry connector(connect with single white line)
DATA BUS: Used for data transmission-connect the PPM IN port of BT-2401A/2402A
AUX1: One key to take off(no need to connect)
AUX2: Hyper IOC(no need to connect)