Motor Unlock - devention Scout X4 Quick Start Manual And Systems Flowchart

'L°0k,
r1/47
of
»scour). o, oa:ao a
01 .SCOUTX6 Ox WOO
00
000
1102 1 11110
dPh
1.201,1,
4.5 Make sure the gimbal move freely in all directions.
The G-3D gimbal is now successfully installed.
5.0 Installing the iLook+ 1080p camera with 5.8ghz video link
5.1 Screw the short "mushroom"
antenna into the camera, use the
included wrench to gently secure
the antenna, do not use force.
5.2 Release the two M2x4 screws
securing the camera mounting
bracket.
5.3 Install the camera into gimbal,
Fix it with camera fixed frame
(ensure the gap close to the
lens), then screw the M2x4
screw to the camera fixed
frame again.
5.4 Connect the cameras power
cable to the power port on the
G-3D gimbal controller.
5.5 The iLook+ camera is now successfully
installed in your G-3D gimbal.
6.0 Motor Unlock
After binding the DEVO F12E to the X4, Check that all trims are neutral,
the throttle stick ALL the way DOWN. the display should say 0% throttle
Check that ALL switches are in the UP position.
You can not start the motors in the GPS hold mode.
Gently push the throttle stick down and move the rudder (YAW) stick to the
left side. (on mode 2 radios throttle and rudder is the same stick)
You will see the RED indicator LED's will tum on, this indicate the
motors are unlocked,
Mode 1(throttle stick on the right) Mode 2(throttle stick on the left)
Be very careful at this point, as pushing the thottle up will start the motors.
You can test by pushing the stick up a little, the motors should start. For your safety, the motors will dis-arm again after 10seconds.
• 3 •