Motorola V120x Instruction Manual page 10

120X
Function
Frequency Range
Channel Spacing
Channels
Duplex spacing
Frequency Stability
Operating Voltage
Display
RF Power Output
Input/Output Imped-
ance
Spurious / Harmonic
Emissions
Audio Distortion
Hum and Noise(C-
MSG)
Modulation
Transmit Audio
Response
Transmit Audio
sensitivity
Transmit Duty Cycle
CDMA Transmit
Waveform
Quality(Rho)
Receiver Sensitivity
Alternate Channel
Desense Protection
Overall System CDMA 800MHz
Table 2:
824.04 - 848.97 MHz Tx,
Channels 1 to 799, f = 0.03 * N+ 825 MHz
Tx
Channels 990 to 1023, f = 0.03(N—1023) + 825 MHz
Tx
869.04 - 893.97 MHz Rx
Channels 1 to 799 is f = 0.03 * N+ 870 MHz
Rx
Channels 990 to 1023, f = 0.03(N—1023) + 870 MHz
Rx
30 KHz
832
45 MHz(amps)
+/- 2.5 ppm (Amps)
+3.6 v nominal (3.0v to 4.4 v DC)
96 X 64 Pixel array 120X have a one line external display to allow viewing of
caller ID and other phone status messages while the flip is closed.
max power 25dBm for CDMA(800 & 1900) and 26.1 dBm for Analog.
50 ohms (nominal)
Complies with Title 47, Part 22 of the code of Federal Regulations.
Less than 5% at -26dB
32 dBm below +/- 8kHz deviation(transmit and receive)
F3: + 12 kHz for 100% at 1 kHz, AMPS (wide)
1M25D1W (1.25 MHz bandwidth) CDMA
6 dBm/octave pre-emphasis
(AMPS)
+ 2.9 kHz deviation (nom.) @ 97 dBm SPL input @ 1 kHz
full, 1/2, 1/4, 1/8 rate (CDMA Mode)
0.94
-116 dBm (AMPS, SINAD, C-MSG weighted) Sinad 12dB or greater
-104 dBm (CDMA, 0.5% Static FER) 0.5% or less
-60 db@+/- 60kHz (Amps)
Specification
10
Product Description
2/26/02