Setup For Analog Call - Motorola V120x Instruction Manual

Set up for Analog call
Display
Data / M eas
Phon e : 11 1-11 1-1 111
A ctiv e ESN (dec) : 15 6-44 603 97
Register ESN (hex) : 9 C440 F6D
SCM : Class IV, Co ntin uo us , 25 M H z
Page
A cces s
Co nn ect
Active
Sys tem T yp e
Register
AM P
Pag e
Cn trl Ch an
Hand off
3 34
Release
Amp litud e
O rder
-50. 0
Ch ng PL 0
dBm
SID
M S Id
23 1
Ph on e Num
1 11 111 11 11
Registration
1. Put the Test Set in Active state by se-
lecting Active from the list on the left side of
the screen.
Select Data from the Data/Meas field.
2.
This is the default mode.
3. Select Register from the list to regis-
ter phone.
4. If the registration message has been
received, the Test Set will display registration
data in the upper half of the screen as shown
in the sample screen above.
Page
1 Select page from the list on the left
side of the screen.
2 If the mobile responds, you will see
theAccess annunciator light briefly.
3 Answer the call by raising the flip or
press SEND on the mobile to start the con-
versation.
4 The Connect annunciator lights. This
is the Connect state.
CALL CONT ROL
V oice Ch an nel Ass is gnment
Chan : - 2 12
4
Pwr L vl : -
5 970 Hz
SAT : -
Select CALL
SCRNS Control panel
ï Select System type: AMPS
ïZero the RF Power meter in the: Call
Config Screen
ïSet Amplitude to:-50 dBm
ïSet SID: Your phoneís System ID
ïSelect: Active
To Screen
ï Voice Channel Assignment Type:
CA LL CNT L
CAL L DA TA
ïChan: 212
CA LL BIT
CAL L CNFG
ïPwr Lvl: 4
ANL G M EAS
SPE C AN L
ï S A T : 5970Hz
A UT H E N
More
Origination
1 Dial the desired phone number on the
mobile station and press SEND.
2 The Access annunciator will light while
the Test Set signals the mobile on the assigned
voice channel.
3 The connect annunciator will light if
the mobile properly signals the Test Set.
35
Motorola Confidential Proprietary
Test Procedures
CTRLfrom the ANALOG