Miller Trailblazer 325 Owner's Manual page 36

Table 6-1. Process/Contactor Switch And Arc Control Settings
.
Arc Control is not active when the Process/Contactor switch is in the following positions:
Output On / Wire / Flux Core
Output On / Stick / Gouge
Remote On/Off / Wire / Flux Core
TIG processes also do not have arc control but process information is included in the table.
Process/Contactor Switch
Voltage sensing feeder
OM-249 795 Page 32
.
Complete Parts List is available at www.MillerWelds.com
Arc Control
SOFT
L (0)
STIFF
SOFT
L (0)
STIFF
SOFT
L (0)
STIFF
Not
Active
Starting point for stainless steel wire (high inductance)
Starting point for mild steel wire
Starting point for aluminum wire (low inductance)
Flat or horizontal welds with XX18 electrode with short weld cables
Starting point for XX18, XX13, XX14, XX24, and XX22 electrodes
Minimizes stickiness with XX18, XX14, XX22, XX24, and XX13
electrodes. Also for pipe welding with XX10 and XX18 electrodes
Starting point for welding pipe with XX10 and XX18 electrodes
Starting point for XX10 electrode/open root vertical down joint
Starting point for pipe welding vertical down with long weld cables
Lift Arc start. No Auto Crater allows full control on pipe welds with
short or long arc length. Auto Stop feature allows arc to be broken
without loss of shielding gas.