Hootoo HT-IP210P User Manual page 35

If it prompts error information as follows:
1) Cannot connect to the server. Please check FTP Server is correct or not.
2) Network Error. Please try later.
3) Server Error.
4) Incorrect user or password. Please check the username and password is
correct or not.
5) Cannot access the folder. Please be sure the folder exists and your
account is authorized
6) Error in PASV mode. Please be sure the server support PASV mode
7) Error in PORT mode. PASV mode should be selected if the device is
behind a NAT
8) Cannot upload file. Please be sure your account is authorized
Please check if parameters you filled in are correct or not. The format of
image is like 000DC5D008FA
(IPCAM) _0_20101115152525_25.jpg
Please check if your FTP server supports this format of file name
Alarm Service Settings
- Motion detect armed: tick to enable motion detection.
- Motion detect sensitivity: to adjust motion detection sensitivity
- Start the motion detection compensation: tick to reduce false alarm of
light mutation
- Alarm input armed: tick to enable external alarm devices (attaches to
camera I/O interface) to transfer alarm signal to camera.
- Trigger level: low/high
- IO Linkage on alarm: tick to enable camera to trigger alarm signal
received from or send alarm order to external alarm devices.