Warranty - Jydepejsen ELEGANCE JUNIOR User Manual

All local regulations, including those which refer to national and European standards, must be observed when installing
a wood-burning stove.
You must ensure that there is sufficient intake of combustion air, also when used with other heating and extraction
devices. Houses today are often so well insulated that it may be necessary to take in fresh air from outside via fresh air
vents. Fresh air vents should not be blocked.
You should also check that the vermiculite plates are correctly fitted inside the combustion chamber. The position of
these is shown in the illustration in this instruction manual.
You must install your stove according to the required minimum distance to combustible materials. See also the boiler
plate on the stove for details.
In addition, it is important to check that the Vermiculite panels are correctly fitted in the combustion chamber.
Floor / foundation / wall
The stove must be installed / hanged on a non-combustible foundation / at a non-combustible wall - i.e. where a tile or
brick floor is non-existing, the stove must meet the demands for the distance to combustible material under / above /
beside the stove, according to applicable legislative requirements. Consult you dealer before installing the stove.

3. Warranty

Brand new wood burning stoves from Jydepejsen A/S come with a 5 year warranty. The warranty includes defects and
burn through with correct operation.
Any claims during the warranty period should be directed to the dealer who sold the stove. All stoves from Jydepejsen
come with their own individual serial number on the type plate on the back of the stove. Please quote stove model
and serial number to your dealer in connection with service tasks. In the event of warranty repairs, a signed and dated
invoice must also be produced, showing the dealer's name. The warranty does not cover dismantling, transport and
reassembly of your stove.
No compensation will be granted for
- Damage during transport.
- Damage to other articles resulting from use of the stove.
- Damage arising from misoperation or incorrect usage, such as overheating – avoid this by reading the operating
instructions carefully.
- The directions in the operating instructions have not been followed.
The stove is supplied with wearing parts, which are to be replaced due to usage of the stove. These parts are not
covered by the warranty – how often they are to be replaced is individual and depends on the stove usage. The wearing
parts are: Vermiculite panels -baffle plates -sealing band.
Furthermore, Glass and soapstone are not covered by the warranty. If any of the above mentioned need replacing, new
parts can be ordered from your dealer.
4. Stoking instructions
It is very important to ensure that your chimney has a decent draught.TheAlpha and Omega is the cooperation between
the chimney and the stove.Your dealer or your chimney sweep will be able to guide and advice you on your chimney
conditions.
When this is settled, the next step is that you make the stove and the chimney cooperate. This is done by following
[GB 2,3]