Volvo Penta 3.0GS/SX Owner's Manual page 26

24
TRIM = Drive position at all speeds. Max trim up to 5.
BEACH = Used for operation at in shallow water
where water depth is uncertain. Speed should always
be low, max. 1000 rpm. 5 - 40.
LIFT = Flashing red warning lamp. Drive up completely
41 - 51. See LEDs position 1.
IMPORTANT! The engine must not be run with
the drive in this position.
LEDs
1 Flashes red within the lift range above 41. Other-
wise out.
2 Constant red light: 6 - 40. Otherwise out.
3 Constant green light: 2 - 5. Otherwise out.
4 Constant green light in the range 0 - 2. Otherwise
out.
5 Constant green light in trimmed range up to 0.
Otherwise out.
6 Constant yellow light in maximum trimmed posi-
tion up to 0. Flashes when above 0. The drive
moves and the bow is lowered. Otherwise out.
7 Constant yellow light. 2 - 5. Flashes when the
drive moves within trimrange and the bow is rai-
sed.
BEACH hold function
Boats with digital trim instruments and separate swit-
ches for bypassing the catch which prevents entry to
the "Beach" area can be equipped with a further
switch with warning lamp, a so-called hold function
(optional). Trimming to and inside the "Beach" area is
done as follows:
Press the button to activate the hold function. At the
same time, trim the drive into the "Beach" area. The
indication lamp is now lit, to indicate that the bypass
hold function is now in action. The drives can now be
trimmed in the "Beach" area by a one-hand opera-
tion, by just pressing the trim adjustment buttons.
The hold function is retained for as long as the drives
remain in the "Beach" area. When the drive is lowe-
red and the drive re-enters the "Trim" area, the catch
which prevents entry to the "Beach" area is re-acti-
vated and the indication lamp goes out.