Error Messages - Pioneer AVH-X8600BT Operation Manual

Appendix
Symptom
The smartphone was not
charged.

Error messages

When problems occur with this product, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
record the error message and contact your dealer or your nearest Pioneer service centre.
Common
Message
AMP Error
Product overheat. System will
be shut down automatically
in 1 minute. Restart the pro-
duct by ACC-Off/On may fix
this problem. If this message
keep showing up, it is possi-
ble that some problem oc-
cured in the product.
Aha Radio
Message
Communication error oc-
curred.
Error-02-6X
Disc
Message
Error-02-XX/FF-FF
Cause
Charging stopped because the tem-
perature of the smartphone rose
due to prolonged use of the smart-
phone during charging.
More battery power was consumed
than was gained from charging.
Cause
This product fails to operate or the
speaker connection is incorrect; the
protective circuit is activated.
The temperature is too high for this
product to operate.
Cause
iPod failure.
iPod failure.
Cause
The disc is dirty.
The disc is scratched.
The disc is loaded upside down.
There is an electrical or mechanical
error.
Action
Disconnect the smartphone from the cable,
and wait until the smartphone cools down.
This problem may be resolved by stopping
any unnecessary services on the smartphone.
Action
Check the speaker connection. If the mes-
sage fails to disappear even after the engine
is switched off/on, contact your dealer or an
authorised Pioneer Service Station for assis-
tance.
Follow the instructions displayed on the
screen. If this does not solve the problem,
contact your dealer or an authorised Pioneer
Station for assistance.
Action
Disconnect the cable from the iPod. Once the
iPod's main menu is displayed, reconnect the
iPod and reset it.
Disconnect the cable from the iPod. Once the
iPod's main menu is displayed, reconnect the
iPod and reset it.
Action (Reference)
Clean the disc.
Replace the disc.
Check that the disc is loaded correctly.
Press the RESET button. (Page 11)
Appendix
133
Engb