Function Settings; Indoor Unit (Setting By Remote Controller) - Fujitsu ASG07LLCC Design & Technical Manual

11.

FUNCTION SETTINGS

11-1.

INDOOR UNIT (Setting by remote controller)

• The function settings of the control of the indoor unit can be changed by this procedure according
to the installation conditions. Incorrect settings may cause an indoor unit to malfunction.
• After the power is turned on, perform the "Function Setting" according to the installation
conditions using the remote controller.
• The settings may be selected between the following two: Function Number and Setting Value.
• Settings will not be changed if invalid numbers or setting values are selected.
PREPARATION
„ „
• Before turning on the power of the indoor unit:
- Confirm whether the piping air-tight test and vacuuming have been conducted.
- Reconfirm whether there is no miswiring.
• Turn on the power of the indoor units.
FUNCTION SETTING METHOD (for Wireless remote controller)
„ „
Entering the Function Setting Mode
While pressing the FAN button and SET TEMP. (
•
„
function setting mode.
STEP 1
Setting the Remote controller Custom Code
Use the following steps to select the custom code of the remote controller. (Note
that the air conditioner cannot receive a custom code if the air conditioner has not
been set for the custom code.) The custom code that is set through this process are
applicable only during the Function Setting process. For details on how to set the
custom code through the normal process, refer to the instructions under "REMOTE
CONTROLLER CUSTOM CODE SETTING".
1. Press the SET TEMP. (
→ → .
Match the code on the display to the air conditioner custom code (initially set to ).
(If the custom code does not need to be selected, press the MODE button and
proceed to STEP 2.)
2. Press the MODE button to accept the custom code, and proceed to
The air conditioner custom code is set to " " prior to shipment.
Contact your retailer to change the custom code.
The remote controller resets to custom code
a custom code other than custom code , reset the custom code after replacing the batteries.
If you do not know the air conditioner custom code setting, try each of the custom codes ( →
you find the code which operates the air conditioner.
STEP 2
Selecting the Function Number and Setting Value
1. Press the SET TEMP. (
(Press the MODE button to switch between the left and right digits.)
2. Press the FAN button to proceed to setting the value.
(Press the FAN button again to return to the function number
selection.)
3. Press the SET TEMP. (
(Press the MODE button to switch between the left and right digits.)
4. Press the SLEEP button, then after you hear the beep emitted from
the indoor unit, the START/STOP button in order to fix the settings.
5. Press the RESET button to end the function setting mode.
6. After completing the Function Setting, be sure to turn off the power
and turn it on again.
After turning off the power, wait 30 seconds or more before turning on it again.
The Function Setting will not become active unless the power is turned off then on again.
Note :
*1) Small "A" is displayed on the right of the custom code during the FUNCTION SETTING.
) button simultaneously, press the RESET button to enter the
) ( ) button to change the custom code between
when the batteries in the remote controller are replaced. If you use
) ( ) buttons to select the function number.
) ( ) buttons to select the setting value.
CAUTION
- (01 - 17) -
→
STEP 2.
→
*1
→ ) until
Function number
*1
Setting value
*1