Husqvarna 357XP/G Workshop Manual page 46

Crankcase and crankshaft –
reassembly
1
357 only:
Fit the cups on the crankshaft.
NOTE!
It is important that the cups are fitted over
the counterweights.
2
Hold the clutch side of the crankcase in a vice. Pull
the crankshaft into its bearing using assembly tools
502 50 30-16.
3
Check that the guide pins are in place. Fit a new
gasket to the mating surface of the clutch side of
the crankcase.
4
Place the flywheel side of the crankcase over the
crankshaft and pull the two crankcase halves
together using assembly tools 502 70 84-01 and
502 50 30-16.
5
Fit and tighten the six crankcase bolts to a torque
of 8–10 Nm. Check that the crankshaft rotates
freely.
Repair instructions
45
English –