Husqvarna 357XP/G Workshop Manual page 43

Repair instructions
3
Fit the inlet manifold 503 86 63-01 to the cylinder.
Check that the impulse tube is correctly seated in
the impulse channel.
NOTE!
It is very important that there are no leaks
in the inlet system, otherwise the engine
may seize.
4
Press the insulating plate 503 86 62-01 onto the
cylinder. Check that the impulse tube connected to
the insulating plate is seated correctly in the inlet
manifold and lock the clamp over the manifold.
5
Lubricate the piston ring and piston with two-stroke
oil.
42
– English
6
Fit a new cylinder base gasket. Compress the
piston ring with tool 502 50 70-01 and lower the
cylinder over it carefully.
7
1
3
Fit the cylinder bolts, tightening them in diagonal
pairs to a torque of 8–10 Nm.
8
Pressure test the cylinder.
9
Refit:
• spark plug, tighten to a torque of 15 Nm
• carburettor, see "Carburettor - refitting".
• silencer, tighten to a torque of 8–10 Nm
• cylinder cover
NOTE!
If a new piston or cylinder has been fitted
the saw must be run for the first 3–4
hours with carburettor adjusted to the
factory settings.
4
2