Throttle Trigger - Husqvarna 357XP/G Workshop Manual

Choke control – refitting
First reattach the choke control to the air filter, then
press it onto the carburettor so that the clips engage.
Then refit:
• stop switch
• carburettor into its rubber mountings
• throttle pushrod into the fuel tank and connect to
throttle lever.
• lift the spring arm over the throttle pushrod
• fuel hose to the carburettor
• air filter and cylinder cover
Throttle lock, throttle trigger and return
spring – removal
1
4
Remove the throttle lock by pressing it to the right
and pulling upwards at the same time until you
hear a click. Then repeat by pressing it to the left
(3) and pulling upwards (4). When both of the lugs
on the lock have cleared the tank pull the lock
backwards.
2
Drive out the steel pin using a 2.5 mm/0.1" diam-
eter drift. Push it out from the flywheel side of the
saw.
2
1
3
3
1
Remove the throttle trigger by first pressing it
towards the clutch side of the saw until it clicks,
then towards the flywheel side until it clicks again.
Remove it from the tank and lift out the return
spring.
Cleaning and inspection
• Clean and inspect all parts carefully. If there are
any cracks or other defects replace the damaged
parts with new ones. Always use original parts.
• Lubricate the throttle lock with oil.
• Check that the spring is not broken and has not
lost its tension.
Throttle lock, throttle trigger and return
spring – refitting
1
A
Refit the return spring to the throttle trigger as
shown. Make sure the spring is correctly positioned
by engaging one end in the slot in the throttle
trigger (A).
Press the coil of the return spring into the handle
and press the short end of the spring (A) into the
recess in the throttle trigger.
Repair instructions
2
17
English –