Husqvarna 357XP/G Workshop Manual page 36

Air intake system – refitting
1
First fit the inlet manifold onto the cylinder. Then fit
the insulating plate and secure it to the cylinder
with the clamp. Check carefully that the impulse
tube is correctly seated in the impulse channel. Fit
the carburettor flange to the inlet manifold.
2
Position tool 502 54 17-01 between the carburettor
flange and the insulating plate.
3
Refit the carburettor. Screw in the carburettor bolts
directly from behind without lifting the carburettor
assembly, tightening to a torque of 1–1.5 Nm. It is
important to hold the carburettor flange securely
when tightening the bolts to prevent the inlet
manifold from moving.
4
Push down the rear carburettor mounting into the
rubber bushings using a small screwdriver. Re-
move tool 502 54 17-01.
5
Refit:
• cylinder, see "Piston and cylinder - refitting"
• silencer support, tighten bolts to a torque of 8–
10 Nm
• bark rest, tighten bolts to a torque of 8–10 Nm
• air filter
• HT lead
• cylinder cover
6
After the test run retighten the silencer bolts to a
torque of 8–10 Nm
Repair instructions
35
English –