Hand Grip Heater - Husqvarna 357XP/G Workshop Manual

Repair instructions
2
First insert the rear edge of the throttle trigger into
the tank. Then push/clip the front edge into the two
clips on the tank with the aid of a combination tool,
for example. Drive in the steel pin from the clutch
side. Use a 2.5 mm/0.1" diameter drift.
3
Then press down the return spring while pressing
the throttle lock forwards/upwards into the retaining
clip in the fuel tank until you hear a click. Release
the return spring in the throttle lock, then press the
lock down onto the tank.
4
Check the operation of the throttle lock by trying to
press the throttle trigger without pressing down the
throttle lock. Also check that the throttle lock and
throttle trigger return freely to their original posi-
tions when released.
18
– English
Hand grip heater on model 357XP/G
and 359/G – removal
No heating or heating only in front hand grip
• Front hand grip – troubleshooting
1
Remove the three bolts that secure the cover over the
front hand grip. Disconnect the leads from the switch
and generator and measure the resistance of the
hand grip heater, which should be 3–4 ohm. Replace
the front hand grip if the resistance is higher.
2
Reconnect the leads and secure the cover back in
place over the front hand grip.