Generator - Husqvarna 357XP/G Workshop Manual

Repair instructions
3
Unscrew the two bolts from the generator but leave
the generator in place.
4
Remove the fuel hose and throttle pushrod from
the carburettor.
Unbolt the rear tank mounting from the crankcase,
i.e. the rear vibration damping spring, and both
stops. Lower the tank as far as it will go to allow
access to the heater lead where it is connected to
the tank.
5
Disconnect the generator lead from the hand grip
and unclip it from the tank. Remove the generator
and lead.
Generator – refitting
1
Feed the generator lead through the holes in the
crankcase and hand grip. Bolt the generator in
position, tightening the bolts to a torque of 5 Nm.
Clip the lead to the tank.
NOTE! The lead connector must be positioned to
the right of the clip. Connect the lead to the con-
nector on the hand grip and refit the cover.
2
Refit:
• fuel tank with both stops and rear vibration
damping spring
• fuel hose to carburettor, hose length between
tank and crankcase: 43 mm (1.69 inches) and
between crankcase and carburettor: 53 mm
(2.09 inches)
• throttle pushrod to carburettor
• flywheel with nut and washer
• cable guide, leads and starter assembly
Remove the piston stop and reconnect the HT lead
and cylinder cover.
24
– English
Ignition module and flywheel – refitting
1
Place the flywheel on the crankshaft. Turn the
flywheel so that the key lines up with the keyway in
the shaft.
Fit the washer and nut on the shaft and tighten to a
torque of 25-30 Nm.
2
To refit the ignition module proceed as follows:
Turn the flywheel so that the magnets are in line
with the ignition module. Fit the ignition module with
the plastic feeler gauge (502 51 34-01) held in
position at the same time, without tightening the
bolts. Connect the black earth lead to the front
screw on the ignition module. Adjust the gap
between the ignition module and magnet to 0.3 +/-
0.1 mm. The gap must be measured at either of the
two lowest pegs on the ignition module. Tighten the
bolts to 8-10 Nm. Connect the blue lead to the
ignition module.