Table of Contents
Advertisement
9-4.
Optional Low Open Circuit Voltage (OCV) Welding Modes
9-5. Alternate Configuration Functions
There are 3 ways that the remote control can be configured to operate on this machine. The configuration of the meters can be changed by placing
the process selection switch into Stick mode and turning the output on and off 3−5 times within a few seconds, this can be done by triggering
a feeder or by activating the output on−off switch on a remote control. The amperage window will briefly display what mode is selected before
returning to preset display
C 1
C 2
C 3
Configuration 1 is the default that the unit leaves the facto-
ry set for. Stick mode recognizes a remote plugged into
the preset output set at the panel, CC mode displays pre-
set panel control instead of the percentage of the remote.
Configuration 2 changes Stick modes remote operation.
When configuration 2 is selected Stick mode operates in
Panel Only control, meaning any remote control that is
plugged into the remote 14 control will be ignored and
have no effect on the output. When Stick mode is active,
a decimal point will be displayed in the amperage window.
Configuration 3 changes how the display works in the CC
mode. When configuration 3 is selected the amperage
window will display the percentage of preset amperage
being set from the remote amperage control, the panel will
set the maximum amperage. When CC mode is active, a
decimal point will be displayed in the amperage window.
Low OCV Operation
The unit can be optionally config-
ured for low open circuit voltage
(OCV) operation in Stick and
Scratch Start TIG modes. When the
unit is configured for low OCV op-
eration only a low sensing voltage
(approximately 15 VDC) is present
between the electrode and the
workpiece prior to the electrode
touching the workpiece. Consult a
Factory Authorized Service Agent
for information regarding how to
configure unit for low OCV welding
operation.
OM-2247 Page 41
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
