Typical Connection For Remote Control Feeder Gmaw-P Process - Miller XMT 350 CC/CV Auto-Line Owner's Manual

8-3. Typical Connection For Remote Control Feeder GMAW-P Process

1
4
5
!
Turn off power before making
connections.
1 Optima - External Pulsing Device
2 Remote 14-Receptacle
3 Positive (+) Weld Output Terminal
4 Negative (−) Weld Output Terminal
5 Ground Cable to Workpiece
OM-2247 Page 34
2
3
7
6
6 Workpiece
7 Gun
8 Wire Feeder
9 Gas Hose
10 Gas Cylinder
Use of shielding gas is dependant on Wire
8
10
9
Type.
.
The connection diagram illustrates
DCEP (reverse polarity) suitable for all
wires except self-shielded FCAW. The
majority of self-shielded FCAW wires
require DCEN (straight polarity). Flux
cored wires are not pulsed. No pulse
program available for FCAW.
264 347-A