Miller XMT 350 CC/CV Auto-Line Owner's Manual page 16

Do not weld on drums or any closed containers.
Do not remove or paint over (cover) the label.
Disconnect input plug or power before working on machine.
Flying pieces of parts can cause injury. Always wear a face shield when servicing unit.
Always wear long sleeves and button your collar when servicing unit.
After taking proper precautions as shown, connect power to unit.
Do not use one handle to lift or support unit.
Kasjf;laksf;lkasdf'l;aksdf;lkasd;flksadflkasd;lk
Kasjf;laksf;lkasdf'l;aksdf;lkasd;flksadflkasd;lk
Kasjf;laksf;lkasdf'l;aksdf;lkasd;flksadflkasd;lk
V
>60sec
= < 60°
OM-2247 Page 12
Wear hat and safety glasses. Use ear protection and button shirt
collar. Use welding helmet with correct shade of filter. Wear complete
body protection.
Become trained and read the instructions before working on the
machine or welding.
V
Hazardous voltage remains on input capacitors after power is turned
off. Do not touch fully charged capacitors. Always wait 60 seconds
after power is turned off before working on unit, OR check input ca-
pacitor voltage, and be sure it is near 0 before touching any parts.
V
Always lift and support unit using both handles. Keep angle of lifting
device less than 60 degrees.
Use a proper cart to move unit.
Safe16 2012−05
Safe20 2012−05
Safe30 2012−05
Safe27 2012−05
Safe28 2012−05
Safe29 2012−05
Safe31 2012−05
Safe38 2012−05
Safe40 2012−05
Safe43 2012−05
Safe44 2012−05