Tig Welding Mode - Gtaw Process - Miller XMT 350 CC/CV Auto-Line Owner's Manual

7-4. TIG Welding Mode - GTAW Process

!
Weld terminals are
through the remote control in TIG
welding mode.
1 Mode Switch
2 Left Display
3 Right Display
4 Adjust Control
2
Setup
energized
For typical system connections refer to
Section 7-1.
Rotate Mode Switch to TIG position as
shown.
The preset amperage is shown in the Right
Display.
3
8 5
1
Operation
The Adjust Control is used to set desired
preset amperage.
A remote control is required to turn on the
weld output.
.
If the remote control has an amperage
adjustment, the adjustment will func-
tion as a percentage of the preset am-
perage.
.
For best results, gently scratch the
tungsten electrode to the work to initi-
ate an arc. To minimize arc flare at the
end of the weld, pull back the electrode
quickly to extinguish the arc.
4
239 083-A
OM-2247 Page 31