Confirmation For Use Of Sub Fence - Hitachi C 12LDH Technical Data And Service Manual

8-4. Confirmation for Use of Sub Fence

(1) Confirmation for use of sub fence (A)
WARNING: In the case of right bevel cutting, turn sub fence (A) clockwise. Unless it is turned
clockwise, the main body or saw blade may contact sub fence (A), resulting in an injury.
This power tool is equipped with sub fence (A).
In the case of direct angle cutting and left bevel angle
cutting, use sub fence (A). Then you can realize
stable cutting of the material with a wide back face.
In the case of right bevel cutting, raise sub fence (A)
up as illustrated in Fig. 19 and then turn it clockwise.
(2) Confirmation for use of sub fence (B)
WARNING: In the case of left bevel cutting, turn sub fence (B) counterclockwise. Unless it is turned
counterclockwise, the main body or saw blade may contact sub fence (B), resulting in an
injury.
This power tool is equipped with sub fence (B). In the
case of direct angle cutting and right bevel angle
cutting, use sub fence (B). Then you can realize stable
cutting of the material with a wide back face.
In the case of left bevel cutting, raise sub fence (B) up
as illustrated in Fig. 20 and turn it counterclockwise.
(3) Confirmation for use of sub fence (C)
WARNING: In the case of left bevel angle cutting, remove sub fence (C). If sub fence (C) is not
removed, sub fence (C) will contact the main unit or the saw blade and result in injury.
This power tool is equipped with sub fence (C). In the
case of direct angle cutting and right bevel angle
cutting, use sub fence (C). (Fig. 21)
Then you can realize stable cutting of the material with
a wide back face.
Left bevel angle cutting
Direct angle cutting
Fence (A)
Left bevel angle
cutting
Sub fence (B)
Fence (B)
--- 15 ---
Right bevel
angle cutting
Turn
Sub fence (A)
Fig. 19
Right bevel angle cutting
Turn
Direct angle cutting
Fence (B)
Fig. 20
Sub fence (C)
Fig. 21