FPI FP90 Owners & Installation Manual page 28

Installing the Top Louver
1) Add two (2) screws (¼-20 X ½") to the front of the
fi replace for mounting the top louver. The screws
must be left loose to allow the top louver to slide
onto them. Adjustment of theses screws will be
needed to get the louver to sit fl ush with the front
of the fi replace.
2) Place the top louver above the mounting screws located
on the front of the fi replace and slide the louver down onto
the screws.
NOTE: Take care not to scratch the paint on the front of the
fi replace when installing the top louver.
Bottom Louver
Frame Rotation Pin Tab (x2)
918-433
WOOD FIREPLACE
REGENCY LOUVERS
Installing the Bottom Louver
1) Fasten the bottom louver frame onto the front of
2) Take the bottom louver and slide it onto the rotation pins
3) Close the bottom louver and secure on the magnets provided
Diagram 1
the fi replace using two (2) screws (¼-20 X ½").
located on the bottom louver frame.
(refer to Diagrams 1 and 2).
Top Louver
Mounting Tab (x2)
Bottom Louver
Rotation Pin Tab (x2)
Bottom Louver Mounting Sequence
R90
Diagram 2
08/23/05