Advertisement
Fan Coil Unit One-Way Cassette Type
in section 4.1
-
Provide the fixing for the threaded rods with suitable tools.
-
Fasten the threaded rods to the building ceiling. The length dimensions depend on the
distance to the intermediate ceiling.
-
Push the unit, with the terminal box facing front, into the intermediate ceiling at an angle, until
the unit is fully placed into the intermediate ceiling.
-
Place the unit straight over the opening. Provisional fast installation is possible using the
hooks on the suspension lugs. After final positioning fix the straps to the unit wall using
tapping screws.
-
Screw the unit firmly onto the threaded rods. Make sure that the unit is exactly horizontal.
5.5.3 Panel installation
NOTE!
-
Check whether indoor unit is horizontal with leveler or polythene pipe filled with water,
and check that the dimension of the ceiling opening is correct. Take off the lever gauge
before install the panel.
The design panel with an air filter is not delivered pre-assembled. The required mounting material
(setscrews) is packed separately in a plastic bag.
-
Loosen the air intake grille by turning each of the 2 locks.
-
Remove the air intake grille. (Refer to below indication fig)
Install the panel board in the right direction, you can follow below steps.
17
Advertisement
Troubleshooting
