Maintenance; Before Using This Appliance; For Outdoor Use Only - IKEA KLASEN User Manual

• For ease of application, apply a small
amount of soap solution to the end of the
regulator hose.
B) On the gas cylinder
• Make sure all device valves are closed.
• Check that the valve on the gas bottle is
closed and remove the protective valve
cover (5).
• AVOID FLAME OR SPARKS!
• Check that there is a seal-ring (6)
attached to the pressure regulator inlet.
• Tighten the nut (7) on the pressure
regulator in the direction indicated by
arrow on the nut itself.
• Open the bottle valve and use soap
solution to check all couplings for gas
leakage .
C) Use
• Open the bottle valve.
• Start the device according to the
manufacturer's instructions.

3. Maintenance

• If the device is unused for an extended
period of time, i.e. in winter, the pressure
regulator should be removed from the
gas bottle. Always protect the pressure
regulator from dirt and mud.
• Regularly check pressure regulator
gaskets.
• To ensure safe functioning the pressure
regulator should be replaced after 10
years of normal usage.
• Always check for leakage before the
equipment is put back into use.
• The pressure regulator does not require
additional special maintenance, but
always check that the outlet ( 2) is
not blocked. Use a needle to clear the
passage if necessary.
• The kit is designed for a working
temperature between -20°C to +50°C.

BEFORE USING THIS APPLIANCE:

1. Please read all of these instructions
and appliance owners manual prior to
installation and use.

2. FOR OUTDOOR USE ONLY!

• Appliance and tank must be in open, well
ventilated
• outdoor area prior to connection end use.
Make sure
• the tank valve is fully closed and not
leaking prior to
• moving or connecting.
• NEVER USE IN A GARAGE OR UNDER
OVERHANGS!
• NEVER STORE A SPARE CYLINDER OR
ANY FLAMMABLE
• LIQUID OR GAS UNDER OR NEAR THIS
APPLIANCE OR
• ANY OTHER HEAT SOURCE.
3. Be sure tank valve and regulator are
proper mating types, with correct
threads or fittings, see manual.
4. Inspect tank valve, regulator, hose and
fittings to be sure they are clean, free
or dirt, debris, not plugged and not
damaged. If damaged replace before
use. See local LP dealer for repairs.
5. Prior to connection, turn all control
valves to the OFF position.
6. Connect regulator to tank valve
according to appliance owners manual.
Handle cylinder with care – the contents
are under high pressure.
7. If good connection has been made,
slowly open tank valve to full open. Use
a soapy water solution to check all gas
connections for leaks before lighting
appliance.
NEVER TEST WITH OPEN FLAME!
IF YOU SMELL GAS OR A LEAK IS FOUND:
• SHUT OFF GAS AT THE TANK VALVE
IMMEDIATELY.
• EXTINGUISH ANY OPEN FLAME, OR OTHER
POTENTIAL IGNITION SOURCE.
• DO NOT USE APPLIANCE UNTIL REPAIRS
ARE MADE BY QUALIFIED LP GAS DEALER.
• DO NOT ATTEMPT TO MAKE REPAIRS
YOURSELF!
• DO NOT USE ANY APPLIANCE, OR PARTS,
EXPOSED TO OR DAMAGED BY FIRE!
8. If not leaking, carefully light appliance
and use according to the instructions in
this manual. This appliance regulator
and tank valve connection may contain
two or more important safety features
such as Excess Flow Control and High
Temperature Activated Shutoff.
8