Electrolux ESL 7220RO User Manual page 35

Hide thumbs Also See for ESL 7220RO:
Table of Contents

Advertisement

Available languages

Available languages

Problem and alarm code
The programme does not start.
The appliance does not fill with wa-
ter.
• The end indicator flashes 1 time
intermittently.
• Acoustic signal sounds 1 time in-
termittently.
The appliance does not drain the wa-
ter.
• The end indicator flashes 2 times
intermittently.
• Acoustic signal sounds 2 times in-
termittently.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• Acoustic signal sounds 3 times in-
termittently.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
12.1 The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa-
ter drops on glasses and
dishes.
Possible solution
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
• The appliance has started the procedure to
recharge the resin inside the water softener.
The duration of the procedure is approxi-
mately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is
not clogged.
• Make sure that the inlet hose has no kinks or
bends.
• Make sure that the sink spigot is not clog-
ged.
• Make sure that the drain hose has no kinks
or bends.
• Close the water tap and contact an Author-
ised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
Possible solution
• The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
ENGLISH
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents