Status Window; Status Indicator Lights - Frigidaire Dishwasher Use & Care Manual

Status Window

The STATUS window, available on some models,
indicates the following activity:
1-24.............
CL....................
MINUTES..........
L0----L6................ Level of Rinse Aid
In the unlikely event the dishwasher
malfunctions, the STATUS window may display
one of the following codes: "i10" - refer to
dishwasher won't run or fill and try to solve the
problem "i20" - refer to dishwasher does not
drain properly and try to solve the problem.
If, after the check, the problem remains, or if
the status window shows other error codes,
contact the Frigidaire Customer Care Center
1-800-944-9044
at
to provide assistance in troubleshooting the
problem and/or locating an authorized service
technician, if needed.
Number of delay start
hours. The last hour
will count down in
minutes.
Close dishwasher
door. The status
indicator lights will
also flash to indicate
current cycle status.
Number of minutes
left in cycle (1-199).
dosage.
. They will be able
OPERATING INSTRUCTIONS

Status Indicator Lights

The CLEAN light will remain on until the door is
opened.
When the SANITIZE option is selected and the
criteria is met, the Sanitized indicator will display
and remain on until the door is opened. If the
sanitization criteria is not achieved, the indicator
will not display. This can happen if the cycle is
interrupted or if the sanitization temperature
could not be reached due to incoming water
temperature significantly below 120
Green Light
When the GREEN LIGHT illuminates on the floor
this indicates that the wash cycle is complete.
F.
0
7