Disassembly; Disassembly Flow; Bottom Plate Block; Main Board Block - Sony XM-N1004 Service Manual

• This set can be disassembled in the order shown below.
3-1.

DISASSEMBLY FLOW

SET
3-2.

BOTTOM PLATE BLOCK

(Page 5)
3-3.

MAIN BOARD BLOCK

(Page 5)
3-4.

MAIN BOARD

(Page 5)
Note: Follow the disassembly procedure in the numerical order given.
3-2. BOTTOM PLATE BLOCK
1 two screws
(+B, TT, B-TYPE, 3 L)
1 two screws
(+B, TT, B-TYPE, 3
– Bottom view –
Note: Please spread a sheet under a unit
not to injure heat sink (main).
XM-N1004
SECTION 3

DISASSEMBLY

4 bottom plate block
L)
3 two claws
2 Remove the bottom
plate block in the
direction of an arrow.
3-3. MAIN BOARD BLOCK
1 three screws
(+P, TT, B-TYPE, 3 L)
hole
boss
– Bottom view –
3-4. MAIN BOARD
4 MAIN board
2 front panel
1 screw
(+P, TT, B-TYPE, 3 L)
1 screw
(+P, TT, B-TYPE, 3
1 screw
(+P, TT, B-TYPE, 3
1 screw
(+P, TT, B-TYPE, 3
5 5
2 screw
(+B, TT, B-TYPE, 3 L)
1 three screws
(+P, TT, B-TYPE, 3 L)
1 three screws
(+P, TT, B-TYPE, 3 L)
3 MAIN board block
Note 2: When installing the MAIN board block,
align two holes and two bosses.
hole
Note 1: Please spread a sheet under a unit
not to injure heat sink (main).
boss
MAIN board
sheet heat transfer
3 sheet heat transfer
L)
L)
1 screw
(+P, TT, B-TYPE, 3 L)
L)
XM-N1004