Remote Operation - Dimplex DF2000L Owner's Manual

Operation
at 1-888-346-7539.
!
NOTE: The heater may emit
a slight, harmless odor when first
used. This odor is a normal con-
dition caused by initial heating of
internal heater parts and will not
occur again.

Remote Operation

The fireplace is supplied with an
integrated On/Off
!
NOTE: Ensure that the fire-
place 3 position switch is set to
the remote control setting, "II". To
operate, push the ON button to
turn fireplace on, push the OFF
button to turn the fireplace
!
NOTE: Before attempting any
operation with the remote control,
pull the plastic insulator strip out
from between the remote casing
and battery cover (Figure 5).
Remote Control Initialization/
Reprogram
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
reinitialize the remote control and
the remote control receiver in the
fireplace:
1. Place the 3-Position Switch
(Figure 4A) in the OFF ("O")
10
remote control.
off.
position.
2. Wait a minimum of 5 seconds
and then place the 3-Position
Switch in the Remote Control
position.
3. Within 10 seconds of chang-
ing the switch position, press
the ON button located on the
remote control (Figure 5).
This will synchronize the re-
mote control and the fireplace
receiver.
! NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
Figure 5
ON
Button
OFF
Button
Plastic Strip
Battery Cover
www.dimplex.com