How To Unbind A Module From The Product; How To Set The Product To Module Mode - Fluke CNX 3000 User Manual

How to Unbind a Module from the Product

You can use one of three different procedures to unbind a
module from the Product.
•
Turn off the module.
•
Push  on the module to turn off the radio in the
module. The module stays on to continue
measurements.
•
Push  on the Product to select the module you
want to unbind and then push . All other
modules stay bound to the Product.

How to Set the Product to Module Mode

You can set the Product to operate as a module so its
measurements can be shown on different DMM setup as
a master. To set the Product to the module mode:
1. Push and hold .
2. Turn on the Product.
3. Release  after MOD shows in the display.
Note
The radio is always turned on when the Product
is in the module mode.
When the radio on a different DMM is turned on and the
discovery procedure starts, the Product is discovered and
a number shows in the display of the Product.
Quality Fluke Products Online at:
GlobalTestSupply
www. .com
Wireless Multimeter
Remote Operation
sales@GlobalTestSupply.com
29