How to Unbind a Module from the Product
You can use one of three different procedures to unbind a
module from the Product.
Turn off the module.
Push on the module to turn off the radio in the
module. The module stays on to continue
measurements.
Push on the Product to select the module you
want to unbind and then push . All other
modules stay bound to the Product.
How to Set the Product to Module Mode
You can set the Product to operate as a module so its
measurements can be shown on different DMM setup as
a master. To set the Product to the module mode:
1.
Push and hold .
2.
Turn on the Product.
3.
Release after MOD shows in the display.
Note
The radio is always turned on when the Product
is in the module mode.
When the radio on a different DMM is turned on and the
discovery procedure starts, the Product is discovered and
a number shows in the display of the Product.
Shop for Fluke products online at:
MyFlukeStore
www.
.com
Wireless Multimeter
Remote Operation
1.877.766.5412
29