Flying The Aircraft; Safety Guide - Tactic TTX403 Instruction Manual

FLYING THE AIRCRAFT

1. Once all setup procedures have been confi rmed, and power has been
removed from the model and transmitter, re-attach the propeller to the model.
IMPORTANT: Be careful to stay clear from moving propellers!!
2. Make sure the airplane's power batteries are fully charged.
3. Move the Tx throttle stick to minimum position, then switch on the Tx power
switch. Turn on the power switch in the model.
4. During the fi rst fl ight, it might be necessary to re-trim the aileron, elevator,
and rudder channels to allow the airplane to sustain level hands-off fl ight. If
further adjustments are required on the ground, beware that the on-board
brushed ESC will still be active (if used).
5. When the fl ight is completed, remove power from the system as described
before. Shut down power to the Rx Control Board fi rst, then the transmitter.

SAFETY GUIDE

The Academy of Model Aeronautics (AMA) has established an Offi cial Safety Code.
Model fl ying MUST be in accordance with this Code in order for AMA Liability
Protection to apply. All questions relating to the AMA Safety Code, liability insurance
program, and other offi cial AMA information can be attained from the AMA:
Academy of Model Aeronautics
5161 East Memorial Drive
Muncie, Indiana 47302
(765) 287-1256 – Business
(765) 289-4248 – Fax
(800) 435-9262 – Membership Services
http://www.modelaircraft.org
http://www.modelaircraft.org/fi les/Memanual.PDF
9