Tactic TTX403 Instruction Manual page 5

Elevon & V-Tail Mixing Functions
The TTX403 includes elevon and V-tail mixing functions, which can be turned on or
off. "Elevon" control consists of a mixture between the elevator and aileron channels,
and is useful for certain types of aircraft (such as a fl ying wing). "V-tail" control
consists of a mixture between the elevator and rudder channels and is useful for
aircraft which have a V-tail. The default setting for all mixing will be "off". To change
the mix setting:
config) or two tones (4ch config) during powerup. This single flash indicates
that the transmitter is in V-Tail mixing and the LED will remain solid afterwards.
V-Tail Mixing
4. To cancel V-tail mixing and activate elevon mixing, turn off the transmitter and
repeat the above procedure. When the LED fl ashes twice during powerup the
elevon mix is enabled and the LED will remain solid afterwards.
Elevon Mixing
5. To cancel all mixes, repeat this procedure again. When the LED remains solid, all
mixes will be off.
ch2 ch4
Left Rudder
1. With the Tx power switch off, move
the right stick to the bottom-right
corner, and the left stick to the bottom-
left corner.
2. While holding the sticks in
these positions, turn the Tx power
switch ON.
3. The transmitter
three rapid tones to confirm the
programming has been changed.
The LED will then flash once
simultaneously with one tone (3ch
ch2 ch4
Right Rudder
Aileron
Function
Elevator Function
will emit
ch2 ch4
Up Elevator
5