Changing Batteries And Notices - Vivax GWC09TB-S3DNA1B Owner's Manual

Operation of wireless remote controller
1.Slightly to press the place with
direction to push the back cover of wireless remote controller.
(As shown in Fig 1.)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention
to the polarity. (As shown in Fig 2.)
4. Attach the back cover of wireless remote controller
NOTE:
When changing the batteries, do not use the old or
●
different batteries, otherwise, it can cause the malf-
unction of the wireless remote controller.
If the wireless remote controller will not be used for a
●
long time, please take them out, and don't let the
leakage liquid damage the wireless remote controller.
The operation should be in its receiving range.
●
It should be placed where is 1m away from the TV
●
set or stereo sound sets.
If the remote control cannot operate normally, please
●
take the batteries out, and then reinsert it 30s later; if
it is also abnormal, please replace the batteries.
If the main unit needs to be remote controlled, please
●
aim remote controller at the receiver of main unit in order
to improve the receiving sensitivity of the main unit.
When the remote controller sends out signal, a mark
●
will flicker for about 1s. The bell will ring if the main unit
receives effective signal.

Changing batteries and notices

, along the arrowhead
12
Fig.1
Fig.2
Sketch map for
changing batteries