LauraStar Magic Evolution 723 User Manual page 7

MagicEVO2-PreEVO2 Anglais
Blowing
A very short press (less than half a second) on the steam control button starts the "blowing" mode.
When blowing mode is chosen each press of the steam control button to give steam restarts the cycle
(lasts 4 seconds).
Vacuum
A long press (more than one second) on the steam control button starts the "vacuum" mode. Vacuum is
engaged at every emission of steam and stops 4 seconds after the end of the jet of steam to guarantee
optimum drying of the fabric.
When vacuum is being used each press on the steam control button to give steam restarts the cycle
(lasts 4 seconds).
Using the Softpressing soleplate.
The Softpressing soleplate must be used for dark materials that are likely to become shiny and synthetic
materials that might stick to the soleplate. Do not forget to remove the Softpressing soleplate after use.
To use the Softpressing soleplate:
1. Insert the tip of the iron into the front of the Softpressing soleplate while keeping the back of the iron
raised
2. Pull the tongue backwards as shown in the diagram. The tongue should not fall back.
Wait for about 2 minutes for the Softpressing soleplate to reach the same temperature as the iron.
CAUTION: Make sure the Softpressing soleplate does not touch mohair, cachemir, velvet and angora!
Iron these materials at a distance. Do not forget to remove the Softpressing soleplate after use.
28.1.2003 10:16 Page 7
5