Checking Coolant Level; Cleaning Grill And Radiator Screen; Checking Brake Pedals And Clutch Pedal; Checking Gauges, Meter And Easy Checker(Tm) - Kubota B3300SU Operator's Manual

BChecking Coolant Level
To avoid personal injury:
A Do not remove radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Check to see that the coolant level is between the
"FULL" and "LOW" marks of recovery tank.
2. When the coolant level drops due to evaporation, add
soft water only up to the full level.
In case of leakage, add anti-freeze and soft water in
the specified mixing ratio up to the full level.
(See "Flushing Cooling System and Changing
Coolant" in "EVERY 2 YEARS" in "PERIODIC
SERVICE" section.)
(1) Recovery tank
A If the radiator cap has to be removed, follow the
caution above and securely retighten the cap.
A Use clean, fresh soft water and anti-freeze to fill the
recovery tank.
A If coolant should leak, consult your local KUBOTA
Dealer.
(A) "FULL"
(B) "LOW"
BCleaning Grill and Radiator Screen
To avoid personal injury:
A Be sure to stop the engine and remove the key
before removing the screen.
1. Check front grill and side screens to be sure they are
clean of debris.
2. Detach the screen and remove all foreign materials
and clean the front of radiator completely.
(1) Radiator screen
(2) Shutter plate
A Grill and screen must be clean from debris to prevent
engine from overheating and to allow good air intake
for the air cleaner.
A If the dust or chaff has accumulated between the
battery and radiator, open the shutter plate and clean
the front of radiator completely.
BChecking Brake Pedals and Clutch Pedal
1. Inspect the brake and clutch pedals for free travel, and
smooth operation.
2. Adjust if incorrect measurement is found:
(See "Adjusting Clutch Pedal" and "Adjusting Brake
Pedal" in "EVERY 100 HOURS" in "PERIODIC
SERVICE" section.)
A Brake pedals should be equal when depressed.
BChecking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker(TM).
2. Replace if broken.
PERIODIC SERVICE
(A) "DETACH"
(B) "PULL"
43