Check Chains; Drawbar; Adjusting Drawbar Length - Kubota B3300SU Operator's Manual

BCheck Chains
Remove the snap pin and adjust the turnbuckle to control
horizontal sway of the implement.
After adjustment, re-set the snap pin.
(1) Turnbuckle
(2) Snap pin
THREE-POINT HITCH & DRAWBAR

DRAWBAR

[B3300SU : Option]
To avoid personal injury:
A Never pull from the top link, the rear axle or any
point above the drawbar. Doing so could cause
the tractor to tip over rearward causing
personal injury or death.
BAdjusting Drawbar Length
When towing an implement, use of (B) hole in drawbar is
recommended.
The acceptable drawbar load is provided in the
"IMPLEMENT LIMITATIONS" section.
(1) PTO shaft
(2) Drawbar
(3) Drawbar pin
Holes : (A),(B)
29