Troubleshooting - ELNA eXperience 660 Instruction Manual

T R O U B L E S H O O T I N G
Condition
Needle thread
breaks
Bobbin thread
breaks
Needle breaks
Skipped stitches
Seam puckering
Slipping fabric
Fabric does not
feed smoothly
Gathering
Machine does not
work
Stitches are
distorted
Sensor
buttonholes do not
work
Noisy operation
Machine stops and
the message Lo
appears.
Machine stops and
message E1 E5
~
appears.
1. The needle is not threaded correctly.
2. The needle thread tension is too tight.
3. The needle is bent or blunt.
4. The needle is not inserted correctly.
5. The thread is either too heavy or too fine for the needle.
1. The bobbin thread is not threaded correctly in the bobbin case.
2. Lint has collected in the bobbin case.
3. The bobbin is damaged and does not turn smoothly.
1. The needle is not inserted correctly.
2. The needle is bent or blunt.
3. The needle clamp screw is loose.
4. The needle thread tension is too tight.
5. The needle is too fine for the fabric being sewn.
1. The needle is not inserted correctly.
2. The needle is bent or blunt.
3. The needle and/or the thread are not suitable for the fabric being sewn.
4. A stretch needle is not being used for sewing stretch, very fine and
synthetic fabrics.
5. The needle thread is not threaded correctly.
6. The foot pressure dial is not adjusted correctly.
7. The wrong needle is being used.
1. The needle thread tension is too tight.
2. The machine is not threaded correctly.
3. The needle is too large for the fabric being sewn.
4. The stitch length is too long for the fabric.
5. The foot pressure dial is not set correctly.
Place lightweight way stabilizer under lightweight fabrics.
teara
1. The foot pressure dial is not adjusted correctly.
2. The correct presser foot is not being used.
1. The feed dog is packed with lint.
2. The pressure foot dial is not set correctly.
3. The stitches are too short.
4. The feed dog was not raised after being lowered.
5. The correct presser foot is not being used.
1. The needle thread tension is too loose.
2. The needle is either too large or too small for the thread.
3. The stitch length is too long for fabric.
1. The machine is not plugged in.
2. A thread is caught in the hook area.
3. The bobbin winder spindle is still in the winding position.
1. The fine adjustment screw is not set correctly.
2. The correct presser foot is not being used.
3. The needle thread tension is too tight.
4. The stitch length is not suitable for the fabric being sewn.
5. Use stabilizer for fine or stretch fabrics.
1. Interfacing is not being used with fabrics.
1. Threads have been caught in the hook area.
2. Lint has built up in the bobbin holder or hook area.
1. Threads have been caught in the hook area.
2. Lint has built up in the bobbin holder or hook area.
3. The machine is not threaded properly.
4. The fabric is too heavy.
1. Machine needs servicing.
Cause
48
See
page(s)
25
18
20
20
20
24
41-42
Change bobbin
20
20
20
18
20
20
20
20
20
25
15
20
18
25
20
11
15
15
5-6
41-42
15
11
16
5-6
18
20
11
9
41-42
23
19
5-6
18
11
use stabilizer
28
41-42
41-42
41-42
41-42
25
20
Contact
Elna
service center