Troubleshooting - ELNA eXcellence 710 Instruction Manual

Warning Sign
(E1-E7)
Audible Signal
pip
pip-pip-pip
peep
pip pi-pi-pi-peep

Troubleshooting

Problem
The needle thread 1. The needle thread is not threaded properly.
breaks 2. The needle thread tension is too tight.
3. The needle is bent or blunt.
4. The needle is incorrectly inserted.
5. The needle thread is not set under the presser foot when start sewing.
6. The fabric is moved too fast when stitching free motion quilting.
7. The thread is tangled around the spool.
The bobbin thread 1. The bobbin thread is not threaded properly in the bobbin holder.
breaks 2. Lint has collected in the bobbin holder.
3. The bobbin is damaged and does not turn smoothly.
The needle 1. The needle is incorrectly inserted.
breaks 2. The needle clamp screw is loose.
3. The fabric is pulled forward when using the open-toe foot.
4. The needle is too fine for the fabric being used.
5. An inappropriate presser foot is used.
Skipped stitches 1. The needle is incorrectly inserted, bent or blunt.
2. The needle and/or threads are not suitable for the work being sewn.
3. A blue tip needle is not being used for sewing stretch, very fine fabrics
and synthetics.
4. The needle thread is not threaded properly.
5. A poor quality needle is used.
Version 1.00
21/04/2022
The selected stitch patter cannot be flipped.
The machine does not work properly due to a problem in
the control circuit.
The Buzzer sounds when:
Normal operation.
Invalid operation or malfunction.
E1-E7 error occurred.
Buttonhole is completed.
Cause
Cause
88
Try this
Select the other stitch
pattern for a mirror image.
Contact the service center
or the store from whom the
machine was purchased.
Reference
Page 21
Page 12
Page 17
Page 17
Page 29
Page 67
Use the spool holder.
Page 20
Page 85
Change the bobbin.
Page 17
Page 17
Page 67
Page 17
Use the correct foot.
Page 17
Page 17
Use the stretch stitch needle.
Page 21
Change the needle.