Before Calling Service Technician; General Operation - Toshiba e-studio 167 Operator's Manual For Copying Functions

6 TROUBLESHOOTING

Before Calling Service Technician

When you encounter trouble using this equipment, check the items listed below.

General operation

Phenomenon
The equipment does not
operate at all.
The equipment does not
operate even when you press
any of the buttons.
Scanning stops before it is
finished. ("Count over"
appears on the display.)
Scanning stops before it is
finished. ("Memory is full"
appears on the display.)
Copying stops before it is fin-
ished. ("Clear paper output
tray: PRESS START KEY."
appears on the display.)
"Saving energy" appears on
the display.
"Sleep mode" appears on the
display.
Copy functions cannot be set. Other functions that cannot
190

Before Calling Service Technician

Usual cause
The power cable is not
plugged in securely.
The weekly timer functions
and the equipment is in the
sleep mode.
A message appears on the
screen.
The equipment is in the
energy saving mode.
When the use of the equip-
ment is managed under
department management,
and the department code
has not been entered.
It has been a short time
since the power was turned
ON.
The number of pages
scanned has exceeded the
maximum value.
The built-in memory of the
equipment has become full.
Approx. 250 sheets of paper
have continuously exited and
the equipment stops copy-
ing to prevent the copied
paper from overflowing from
the tray.
The equipment is in the low
power mode.
The equipment is in the
sleep mode.
be set simultaneously with
copy functions have been
set.
Countermeasure
Plug in the power cable securely.
Press any button on the control panel.
Check the message and take any coun-
termeasure accordingly.
P.170 "When This Message Appears"
Press the [ENERGY SAVER] button to
cancel this mode.
P.37 "Saving energy when not in use -
Energy saving mode -"
Enter your department code.
P.36 "Preparation 1 - Turning Power
ON"
P.139 "Department Code"
Wait for the completion of warm-up and
then try again.
Select "Print" on the LCD screen to copy
the data scanned so far. Select "Cancel
job" to delete all the data scanned so far.
Select "Print" on the LCD screen to copy
the data scanned so far. Select "Cancel
job" to delete all the data scanned so far.
Remove the paper from the receiving tray,
and then press the [START] button. Copy-
ing resumes.
Press the [CLEAR/STOP] button to end
the copy job. "Memory clear?" appears on
the LCD screen. Select "YES", and then
press the [START] or [ENTER] button.
The equipment automatically enters into
this mode when a specified period of time
has passed since its last use. Copying is
enabled.
The equipment automatically enters into
this mode when a specified period of time
has passed since its last use. Warm-up
starts either when print data are received
or when any button on the control panel is
pressed. Copying is enabled when the
warm-up has finished.
Some functions cannot be combined set
together.
P.207 "Copying Function Combination
Matrix"