During Maintenance Or Inspection; When Handling Supplies - Toshiba e-studio 167 Operator's Manual For Copying Functions

Other points
Do not turn the power OFF with jammed paper left inside the equipment. This could cause
malfunctions when the main switch is turned ON next time.
Be sure to turn the power OFF when leaving the office or if there is a power failure.
Be careful because the paper exit area and paper just after exiting are hot.
Do not place anything other than paper on the receiving tray. This could disturb a normal
operation and cause malfunctions.
Do not touch the photoconductive drum surface or the transfer charger. This could cause
image problems.
Do not open/close the covers and the bypass tray, or pull out the drawers during printing.

During maintenance or inspection

Warning
Never attempt to repair, disassemble or modify the equipment by yourself. You could cause
a fire or get an electric shock.
Always contact your service representative for maintenance or repair of the internal parts of
the equipment.
Do not let liquids such as water and oil get into the system when cleaning the floor. This
could cause a fire and give you an electric shock.
Caution
Always keep the plug and outlet clean. Prevent them from accumulating dust and dirt. This
could cause a fire and give you an electric shock due to the heat released by electric leak-
age.
Other points
Do not use such solvents as thinner or alcohol when cleaning the surface of the equipment.
- This could warp the shape of the surface or leave it discoloured.
- When using a chemical cleaning pad to clean it, pay attention to any cautionary points.

When handling supplies

Warning
Never attempt to incinerate toner cartridges. This could cause an explosion. Do not dispose
of used toner cartridges. Contact your service representative.
General Precautions 23