Lamp Mode; Buzzer On/Off - Shimano Nexus Service Instructions Manual

Changing the entry data
Switch the suspension to MANU from AUTO mode when inputting data. This step is not necessary when suspension is
not connected to the system. Approximately 5 seconds after the bicycle stops, the battery indicator located on the
FLIGHT DECK will stop displaying blocks to save energy, even if there is power remaining in the battery. The backlight
is off when changing data.
Method
(1) Preparation of Set up
Make sure the speedometer reads
0km/h.
If battery power is low, spin the front wheel or ride the
bicycle for a short time. Then confirm that speed is
0km/h (mph) and that the battery indicator is showing
sufficient power. If power runs down too much while
inputting data, spin the front wheel again.
(2) Start of Set up
After completing preparations, press and hold the
shifting mode select switch on the right shifting switch
for at least 5 seconds. Confirm that only the battery
indicator, a number and the estimated distance are
displayed. Use the right shifting switches (Up/Down) to
select the items to be changed. After making the
desired setting, press the shifting mode select switch to
register the data.
Shifting mode select
switch
Press for at
least 5 seconds
Accept
Accept
Accept

• Lamp mode

• Buzzer On/Off

• ODOmeter clear
Verify that the display is flashing.
Press the right shifting switch (Up/Down) to set the desired
display.
<Right-hand>
Shifting Up/Down switch
When the desired setting appears, press the shifting mode
Push
select switch to set.
Buzzer On/Off mode is like below.
After confirming display shows Battery and "b on" or
"b off", push Shifting mode select switch.
Confirm the number flashes.
If you want to buzzer \ Set that "b on" flashes.
If you don't want to buzzer \ Set that "b off" flashes.
When the desired setting appears, press the shifting mode
select switch to set.
Verify that the display is flashing. Press the right shifting
switch (Up/Down) to clear the display (km/mile).
Lamp mode
To set the lamp to AUTO To set the lamp to always on
To set the lamp to always off
When set to AUTO, the
lamp automatically turns on
when the surroundings
become dark.
Buzzer On/Off
Ex. In case of buzzer on. Ex. In case of buzzer off.
ODOmeter clear
Ex. In case of odometer
is 300 km