Shimano Nexus Service Instructions Manual page 10

After checking the display, press the shifting mode select
switch to confirm. The travelling distance will also be
cleared at this time. If you do not want to clear the data,
press the right shifting switch (Up/Down) to display the
current cumulative distance, and then press the shifting
mode select switch to confirm.
• Clock setting
• Travelling distance Clear
Clock setting
Condition of setting
(1) Wait unit the speed indication
shows "0" to remove the FLIGHT
DECK from the bicycle.
(2) Verify that the low battery
display is not flashing.
Display select switch
Press for at least 3 seconds
Method of setting
ex. Adjust to 12:30
• Press the display select switch to
display the clock.
• Keep pressing the display select
switch for 3 seconds or more.
• After confirming that the left side
digit is flashing, press the display
select switch to change the
display to "1".
• Keep pressing the display select
switch for 3 seconds or more to
confirm the setting and move to
the next digit to be set.
• Set each digit in order from left
to right.
• After the minutes have been set,
the display will return to the
normal display.
• If the setting procedure is not
carried through to completion,
the display will return to the
normal display after about 2
minutes and any numbers that
have been entered up until that
point will be canceled.
Travelling distance Clear
Condition of setting
(1) Wait unit the speed indication
shows "0" to remove the FLIGHT
DECK from the bicycle.
(2) Verify that the low battery
display is not flashing.
Display select switch
Press for at least 3 seconds
Method of setting
• Press the display select switch to
display the travelling distance.
• Keep pressing the display select
switch for 3 seconds or more.
• After confirming that the current
travelling distance is flashing,
press the display select switch to
change the display to 0 km (or 0
miles).
• The display will change between
the current travelling distance
and 0 (km or miles) each time you
press the display select switch.
• If you would like to clear the
current travelling distance, check
that the display is cleared (0 km
or 0 miles) and then keep
pressing the display select switch
for 3 seconds or more.
• To return to the original display
without clearing the current
travelling distance, display the
current travelling distance and
then keep pressing the display
select switch for 3 seconds or
more.
• If the travelling distance clearing
procedure is not carried through
to completion, the display will
return to the normal display after
about 2 minutes and any numbers
that have been entered up until
that point will be canceled.