Advertisement
(6)STOP mode
The system is in the STOP (Ret Lock in CAMERA
mode)
position; the S and the T pole bases are snap-fitted
to the
drum base, the S brake is in contact with the S reel base,
and the Tu brake is in contact with the Tu reel base.
S main brake
Tu main brake
9-2. Cassette controller assembly
<Removing>
(1)Apply DC3V to the loading motor to set the standby mode.
Press the lock lever in the arrow direction to move up the
cassette controller.
(See Fig. 1, direction @ or @)
(When the lever is pressed in the direction @, gently raise
the cassette controller
to release.)
(2)Remove
the screws 0
and @ shown in Fig. 2 and Fig. 3,
and remove the Down guide 0.
(3)Remove
the screws @, 0,
@, and @$ shown in Fig. 2,3 and
4, raise the side plate @ in the direction
K to remove it.
Note) When removing the cassette controller,
take care so that
the drum motor FPC provided between the side plate @
and the top cover @ is not damaged and so that the drum
is not damaged.
<Installing>
(1)Apply DC3V to the loading motor to set the standby mode.
(2)lnstall the side plate 0.
VL-PDI U
S pole base
\
T pole base
STOP mode diagram
Lock lever
Fig. 1. Lock lever.
1) Lower the cassette controller assembly in the direction contrary to K in Fig. 4, and fit the screws @ and @ as shown
in Fig. 4. Tightening
torque 40 + 4mN.m (0.4 + 0.04kgcm).
Before fitting the screws @ and @j make sure that the
side plate positioning
section 0
engages with the down switch angle in fig. 2.
Note) When lowering the cassette controller
assembly
in the direction contrary to K, place the drum motor FPC
between the side plate @ and the top cover @. At this time be careful so that FPC is not damaged. Take care
so that the drum is not damaged.
0 Side plate positioning J
A+
Fig. 4
.
@ Down guide
/
/
0
@ Down switch angle
Slide chassis
\
@I Down guide positioning
Fig. 2.
9-3
Advertisement
