Advertisement
VL-PDl U
9. MECHANICAL
SECTION ASSEMBLY AND PARTS REPLACEMENT
(DISASSEMBLY
AND REASSEMBLY)
Mechanical
section disassembly
and reassembly
are explained
in this section.
For removal of the cabinet, etc., refer to 4. DISASSEMBLY
OF THE SET.
<Precautions>
1. Always replace cut washers that have been removed, for example in parts replacement,
with new ones.
2. When reassembling,
be careful not to allow screws, washers or foreign matter to enter. They can cause mechanical
misoperation.
3. Use the cleaning
liquid, oil, grease and screw lock that are specified
below.
Use of any other kind can cause
mechanical
misoperation.
.
011
l
Grease:
Cosmo Petroleum
: Cosmo Hydro HV22/HVlOO
Dow Corning : Moly Coat YM-103
Screw lock:
Three Bond :1401B
Cleaning
liquid: Industrial-use
ethyl alcohol
4. Turn the mechanical
section over, do not place it on, for example, a desk. Deformation
and scratching of mechanical
parts can cause trouble.
9-I.
On the mechanical
modes
To operate the mechanism,
apply DC3-4V
to the loading motor.
At this time, disconnect
the loading motor FPC from the connector.
(l)EJECT
mode
The mechanism
position to take out the cassette where
the EJECT lever is extremely
shifted in the A direction.
(It
is impossible
to lock the cassette controller
assembly
in
this mode.)
EJEC T lev
\
EJECT mode diagram
(2)STANDBY
mode
The mechanism
position
to set the cassette
where the
slide chassis is at the farthest position from the drum and
the EJECT lever is i n clockwise
rotated position
where the cassette controller
assembly
can be
(position
3
0
Slide chassis
STANDBY
mode diagram
Advertisement
