Baxi windermere TF Installation And Servicing Instrucnions page 17

9.0 Annual Servicing – Page 17
Supplied By www.heating spares.co Tel. 0161 620 6677
9.2 Preparation
1. For reasons of safety and economy it is important to
service the stove annually.
WARNING: Isolate the gas supply to the appliance
before servicing.
2. For Grasmere models see section 9.3 Grasmere.
3. For Windermere models see section 9.4 Windermere.
9.3 Grasmere
1. Unscrew the brass door knob and open the door (Fig.
26).
2. Remove the coal guard (Fig. 27) and remove all the
coals.
3. Manoeuvre the ceramic base (Fig. 28) out of the stove
and place carefully to one side.
4. Remove the two sidecheeks, noting their orientation
(Fig. 29).
5. Undo the screw and nut retaining the pilot shield
bracket and remove the bracket (Fig. 30).
6. Undo the disconnecting union on the gas supply.
7. Pull the control knob off the tap and undo the screw
retaining the plate (Fig. 31).
8. Undo the brass locknut holding the tap to the mounting
bracket (Fig. 31).
9. Undo the screw and remove the data badge plate (Fig.
32).
10. Disconnect the two leads from the spillage monitoring
device (Fig. 33).
11. Carefully manoeuvre the burner/controls assembly out
of the stove (Fig. 32).