Operation Procedure Of Diag Menu And Sub-Menu; Functions Available During Diag; Initial Settings Used To Start Diag Function; Main - Yamaha DSP-AX620 Service Manual

Operation procedure of DIAG menu and SUB-MENU

There are 14 MENU items and some SUB-MENU items as well.
DIAG menu selection
Main unit: Jog dial w(forward)/q(reverse)
Remote control unit: Cursor N(forward)/B(reverse) key
SUB-MENU selection
Main unit: DSP PROGRAM (forward)/EFFECT (reverse) key
M
Remote control unit: Cursor
Only the remote control keys indicated in the Menu List can be used to select a sub menu
directly.

Functions available during DIAG

In addition to the DIAG menu, functions as listed below are available.
• Input selection, 6CH input
• Center/Rear/Sub-woofer level adjustment
• Muting
• Power on/off operation
• Master volume
* It is possible to confirm Menu No.12 "IF STATUS" while keeping the signal process (opera-
tion status) of each DIAG menu by using the INPUT MODE key of the main unit.

Initial settings used to start DIAG function

Following initial settings are used when starting the DIAG function.
When the DIAG function is canceled, the settings before starting DIAG will be restored.
• Input
• Master volume
• Center/Rear/Sub-woofer level
• Audio mute
• Speaker settings

MAIN

CENTER
REAR
BASS OUT
MAIN LEVEL
• DIAG menu
<
(forward)/ (reverse) key
: DVD (6CH INPUT OFF)
: -40dB
: 0dB
: OFF
: LARGE
: LARGE
: LARGE
: BOTH
: Normal (0dB)
: DSP THROUGH (1. ANALOG BYPASS)
DSP-AX620
DSP
PROGRAM EFFECT
– +
12