Charger Safety - Oregon CS250 Original Instruction Manual

OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250
• Do not immerse the battery pack in
water or expose it to extremely wet
conditions Moisture can cause the
protective features to be damaged,
resulting in charging with extremely
high current and voltage, which may
lead to abnormal chemical reactions
• To recharge the battery pack, use the
battery charger specifically designed
for the battery pack and observe the
specified charger safety precautions
detailed in this manual Failure to do so
may result in extremely high current and
voltage, which may lead to abnormal
chemical reactions
• Do not use OREGON® branded battery
packs in non-OREGON® branded tools
• Do not strike, pierce, or throw battery
pack
• Do not use an apparently damaged or
deformed battery pack
• If the recharging operation fails to
complete even after the specified
recharging time has elapsed,
immediately stop further recharging
• If the battery pack gives off an odor,
generates heat, becomes discolored
or deformed, or in any way appears
abnormal during use, recharging, or
storage, immediately remove it from the
equipment or charger
• Any liquid leaking from the battery is
corrosive, can damage eyes and skin,
and may be toxic if swallowed

CHARGER SAFETY

IMPORTANT SAFETY INSTRUCTIONS
— SAVE THESE INSTRUCTIONS
CAUTION: THIS APPLIANCE IS NOT
INTENDED FOR USE BY PERSONS
(INCLUDING CHILDREN) WITH
REDUCED PHYSICAL, SENSORY OR
MENTAL CAPABILITIES, OR LACK
OF KNOWLEDGE, UNLESS THEY
HAVE BEEN GIVEN SUPERVISION
OR INSTRUCTION BY A PERSON
RESPONSIBLE FOR THEIR SAFETY.
AF 0513 - F/N 547361
CHILDREN SHOULD BE SUPERVISED
TO ENSURE THAT THEY DO NOT PLAY
WITH THE APPLIANCES.
CAUTION: RISK OF INJURY FROM
ELECTRIC SHOCK AND FIRE. CHARGE
ONLY WITH LITHIUM ION BATTERIES
INTENDED FOR THIS APPLIANCE.
THIS CHARGER IS INTENDED FOR
DRY LOCATION USE ONLY. BEFORE
USING THE CHARGER, READ AND
UNDERSTAND ALL INSTRUCTIONS
AND SAFETY MARKINGS IN THIS
MANUAL, ON THE CHARGER AND ON
THE BATTERY PACKS.
CAUTION: USE THIS CHARGER
ONLY WITH THE SUPPLIED POWER
CORD, MAKING SURE THAT THE
INPUT PLUG CORRECTLY MATES TO
THE OUTPUT RECEPTACLE.
• Do not expose the charger to rain
• Disconnect the charger from the power
supply when not in use
• Do not disassemble the charger THERE
ARE NO USER SERVICEABLE PARTS
INSIDE Take it to an approved service
location when repair is required
• Do not use the charger if it has been
dropped, received a sharp impact, or
otherwise damaged in any way Replace
or take the charger to an approved
service location immediately
• To reduce the risk of injury, charge only
the lithium ion batteries specified for
the charger
• Do not operate the charger with
a damaged cord or plug Replace
damaged power cord with the power
cord part number located in the
instructions See "Specifications and
Components" in this manual
• Locate the cord so that it will not be
tripped over, stepped on, or otherwise
subjected to potential damage
• Never unplug the charger by pulling on
the cord; always pull by the plug
SAFETY RULES
11