Fujitsu FUTRO S700 Operating Manual page 57

Operation
Network Boot Protokol
Boot Order
Show Config Message
Show Message Time
<ESC>
Quit
Configuration menu screen.
The following settings are possible:
Network Boot
Protocol:
Boot Order:
Show Config
Message:
Show
Message
Time:
The settings are not effective until after saving and another PXE system boot.
Fujitsu Technology Solutions
Realtek RTL 8139 / 8130 / 810x BOOT Agent
Configuration Menu v2.13
<Space>
PXE (standard)
or RPL
Int 19h
PnP/ BEV (BBS)
ROM Disabled
Int 18h
The following message can be activated or deactivated during the
system boot:
Realtek RTL8139(X)/8130/810X Boot Agent Press Shift-F10
to configure .......
Indicates the time in seconds for which the following message is
displayed during the system boot:
Realtek RTL8139(X)/8130/810X Boot Agent Press Shift-F10
to configure .......
PXE
Int19h
Enable
3 Seconds
Specification of the system boot protocol used.
The network is always started first before the local
devices are activated.
If a BBS-BIOS (BIOS Boot Specification) exists,
the system is started by the BBS-BIOS.
The entire mechanism for the system boot is
deactivated. The system can only be activated via
the local devices.
The devices set in BIOS Setup are enabled.
English - 17
[RLP]
[PnP/BEV(BBS)
/ROM Disabled/
Int18h]
[Disable]
[5 / 8]
<F4>
53