Material And Solvent Precautions - Nordson A7A Product Manual

10
A7A Airless Spray Gun
Maintenance and Repair
Material and Solvent
Precautions
Manual 4-6
(contd.) Do not attempt to service electrical equipment if there is standing
water present. Do not service electrical equipment in a high-humidity
environment.
Use tools with insulated handles when working with electrical
equipment.
Keep high-voltage connection points clean and insulated with
dielectric grease or oil.
Do not attempt to service a moving piece of equipment. Shut off the
equipment and lock out power. Secure equipment to prevent
uncontrolled movement.
WARNING: Hot! Risk of burns. Wear heat-protective clothing,
eye protection with side shields and/or heat-protective gloves.
Heated materials may cause severe burns on contact. Remember that
some materials, even solid materials, may retain heat for some time. If
you are burned by a heated material, immediately cool the affected skin
with lots of cool, clean water. Do not try to remove hot, melted material
from the skin. Seek immediate medical attention.
High-pressure fluids, unless they are safely contained, are extremely
hazardous. A jet of high-pressure fluid can act like a knife or needle,
penetrate skin and muscle, and inject itself into your body. Injected fluids
can cause toxic poisoning.
Do not treat an injection injury as minor. Seek medical care immediately.
Inform the medical staff at the hospital that you have an injection injury
and identify the fluid that was injected. If possible, give the doctor copies
of the MSDS for the injected fluid and for any additives, such as solvents,
that are in the injected fluid.
Also, Nordson recommends that you carry a National Safety Equipment
Manufacturers Association (NSEMA) wallet card to give to emergency
medical staff in the event of an injection injury. These cards are supplied
with the equipment. Additional cards are available free from Nordson
Corporation.
107 966E
Issued 1/98
1998 Nordson Corporation
All rights reserved