Troubleshooting - Progear Fitness Air Elliptical Owner's Manual

Progear fitness air elliptical owner's manual
Table of Contents

Advertisement

PROBLEM
The computer will not power up.
There is no readings on the computer
display.
The elliptical makes a squeaking
noise.
Clicking Noise.

TROUBLESHOOTING

1.
Check that the batteries are inserted
properly with the correct polarity (see
marking inside the battery compartment).
2.
Check that the battery springs are in
proper contact with batteries.
3.
Remove the old batteries and replace with
the new batteries.
1.
Check that the Sensor Wire (78) coming
out from the Mainframe (59) is securely
connected to the Extension Sensor Wire
(10) coming from the bottom of the Hand
Pulse Handlebar Support Frame (41).
See Step 4 page 13.
2.
Check that the Extension Sensor Wire
(10) coming out from the top side of the
Hand Pulse Handlebar Support Frame
(41) is securely connected to the wire with
a male connector coming out from the
Computer (29). See Step 6 page 16.
3.
Check that the two Hand Pulse Sensor
Wires (35) from the hand pulse handlebar
are connected to the two wires with female
connectors coming out from the Computer
(29). See Step 6 page 16.
1.
The bolts may be loose on the elliptical,
please inspect and tighten any loose
bolts.
2.
See page for lubrication.
After prolong use, the chain may get loose and
start to have a clicking noise. Open the Right
& Left Covers (83, 84) to reach the Nut (48).
Tighten the chain by turning the Nut (48)
clockwise. Repeat for the other side.
23
SOLUTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents